Register To Comment
Results 1 to 4 of 4

Thread: Electric Hammer/axe

  1. #1

  2. #2
    is my test of my mech, will find some pics too

    Mine is a 2 stage chain running to about 6:1.

    Sadly this was due to space constraints with the shape of the robot.

    Motor
    ¦
    9:14
    . . ¦
    36:9
    ¦
    AXE>>>>>>>>

    will confirm soon
    Last edited by Roboteernat; 5th September 2019 at 16:38.

  3. #3
    onyx_build33_zpsbb1171af.jpg

    Later swapped out the drill motor for a scooter motor but the layout remained pretty much the same.

    Axe arm bolted on to the large sprocket, ran on a speed controller and I just pulsed it to control the swing and not over-swing/hit the chassis.

  4. #4
    Ocracoke's Avatar
    Team Kaizen

    20190905_140653.jpg

    Ampflow F30-150 connected to a MOD 1.25 20T pinion gear, going to a 70T and then a 20T to a 90T final output gear which the Scythe axe is bolted to. This results in a 15.75:1 ratio. This setup isn't ideal as it has little shock resistance. A chain drive like Jamie and Nat's have as a final 3rd stage reduction would be preferable.
    Team Kaizen - Build Diary for all the robots

    AW: Amai, Ikari, Lafiel, Osu, Ramu
    BW: Shu!, The Honey Badger
    FW: Azriel
    MW: Jibril, Kaizen

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •