Register To Comment
Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13

Thread: BOB BW Series

  1. #11
    Redirect Left's Avatar
    Roboteer

    Status
    Offline
    Name
    Adam
    Robots
    Hyperion (BW) Modus Operandi (BW) Dead Meme (FW - WIP)
    Location
    Wakefield, West Yorkshire
    Posts
    180
    There's plenty of force in it too, this is what it did to 1.8mm titanium, and underneath it is 10mm aluminium

    p5u8Wu!LaD.jpg

  2. #12
    Been working on BOB2 to take on Robonerd and to use if there's a season 3 Bugglebots.
    BOB2 is what the FW BOB4 going to be with the axe and other things.
    Got it all wired up ready to test the weapon, fuse blown no problem got one with a higher amp, tried again and now this.
    20190829_183949.jpg
    I know there's a hobby shop next to my old job where I get a new motor. If I can't get one it'll have to go in weapon less on Saturday.

  3. #13
    You could probably straighten that shaft with a panel pin hammer and the flat anvil bit on your vice

    but is does require a steady hand

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •