Register To Comment
Page 10 of 12 FirstFirst ... 89101112 LastLast
Results 91 to 100 of 112

Thread: BOB FW Series

  1. #91

  2. #92
    wooh, that some over kill chain there, fm2 using 06b which is used in HW drive, i mean if you already got it then ok but i would look at either t8f chain aka minimotor chain (a bigger 8mm chain 05b sporkets work) or 06b

  3. #93

  4. #94
    ive not had a chain break nor split in Wanna choppa, and thats had some forces on it. Although not as powerful as some axe bots, its been ok on 06b. but as you have bought it, consider the 06b if you need to save weight!

  5. #95

  6. #96
    Well, the driving issue has decide to come back. Unfortunately, I wasn't able to fix it back then at Robodojo and with the Loctite blue I used to keep the wheel from sliding off, I had to cut behind the wheel. From the looks from one of it seems a bit worse than last time.
    20200207_161130.jpg

    Luckily I still got some length left on the shaft and if it happens again.

    But now the next problem is this.
    20200207_161136.jpg
    20200207_161148.jpg

    The screw hole doesn't go all the way in, now I have drill bits for metal but I don't have any tools to make a thread to put a screw in.

  7. #97
    A full tool kit is essential if you wish to be a amateur engineer Sean as apposed to a assembler.

    You can buy a set of Taps and Dies for around £15 and that would suit well for most re threading

    tasks you will encounter.
    Last edited by team death; 9th February 2020 at 09:57.

  8. #98

  9. #99
    If you have never used Taps and Dies before make sure you lubricate the metal before you

    start cutting the thread-cutting oil or gell is best.

    Only cut in 1/4 turns otherwise you may break the Tap or Die-they are very brittle.

    Oh !-very important-turn back 1/4 turn to break off the swarf

    otherwise the cutter will jam and get too tight to turn.
    Last edited by team death; 9th February 2020 at 10:00.

  10. #100

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •