Register To Comment
Results 1 to 7 of 7

Thread: Neumotor 8019 strip down

  1. #1
    Well, in one of my last trips to the US I picked up a couple of Neumotor 8019 motors and very nice they are

    The shafts are designed for collet mount and I wanted to put a pinion on with a keyway. Therefore I had to strip the motor down to get the shaft out.
    I also wanted to see how the statement "The motors feature shafts that can be configured for both front or rear mounting." works and when I spoke to them they stated that

    These are what they looked like initially


    I then pulled them apart


    The shaft is interesting. I was hoping for something simpler as it could do with being a bit longer for the pinion I have. Not feeling optimistic on that

    You can see how the shaft bolts into the magnetic ring


    The windings in all their glory. Could be a bit neater


    The motor does have 2 bearings front and back made by NSK in Japan
    The magnets have spacers but some epoxy would be handy

    Oh, and I still cant figure the shaft out for reversing....

  2. #2

  3. #3
    Did they mention a price?

  4. #4

  5. #5
    The shaft isn't too complex. I'm sure any half decent machining outfit could make you a replacement fairly quickly.

  6. #6
    Some times its just easier to buy parts if the price is right.

  7. #7
    I don't disagree there!

Register To Comment

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •