Register To Comment
Results 1 to 6 of 6

Thread: What is a good rpm range for a beetle vertical disc spinner of 3 - 400g?

  1. #1

  2. #2
    For a decent bite and consistent hits, i would say between 6k and 10k RPM sounds good
    Last edited by Andy; 7th July 2016 at 00:23.

  3. #3

  4. #4
    I think going higher than 10k, you would get a few good hits but not as many, in my opinion

  5. #5

  6. #6
    It depends on the number of teeth on the weapon as well, not just speed. In fact the fast you go the less bite you get.

    If its single tooth, gear it for 10'000rpm, but unless someone is ramming you that is still to fast to engage. If you are in close, dropping it down to half throttle (which with increasing resistances at high speed means around 6000rpm real world) which will be much better.

    If its a dual tooth weapon, then gear it for ~8'000 and be prepared to run it at a slower speed to get engagement.

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •