Register To Comment
Results 1 to 5 of 5

Thread: Titanium thickness?

  1. #1

  2. #2
    6 mm

  3. #3
    Given my robot Anvil was reduced to scrap and was made of 1.5mm Grade 5 Titanium... thciker than that. But Newton didn't just break the welds, it cut clean through it leaving 30-40mm long cuts, you may want something less expensive that doesn't require a welder to fix.

  4. #4
    6mm would render you pretty safe but is somewhat overkill.
    A 3mm plate at an angle should deflect enough.

    Seeing as each spinner has it's own angle, you'll never be fully safe...
    Even 6mm thick titanium can be ripped off if hit right...

    As always in these matters, it all boils down to the moment and the effect in play.

  5. #5

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •