Just letting you all know that the perm motors out off ceros are know for sale, used at durham this wwekend and are in tip top condition are like new, ceros is just too compact for theses motors and I don't have the funds to by a mega wotty to run them at there full potential, will be removed by the end off the week for photos etc.
pm me with your interest and open to offers
As promised motor specs, around about 4hp per motor.
Specifications:
Voltage: 12/24VDC
Weight: 7.5 lb
Size: 5.9" diameter, 3.5" long
Shaft: 12mm diameter x 27mm long
Shaft has threaded hole, M6 x 12, 16.2 mm deep
Mounting holes are M6 x 15, 13.8 mm deep
Wires: two 8 gauge, about 1.5 feet long each
Angular-velocity constant: 291 rpm/V
Torque Constant: 4.67 ozf-in/A
No-Load current: 7.8 A
Rotor Inertia: 115 oz-in²
Inductance: 2.6 µH
Continuous current: 78 A
10 min current: 115 A
12v = 3390 r/min = 0.958 hp
24v = 6880 r/min = 3.95 hp
how much are you looking for?
Retail at £450 each ish, feel free to make an other
might be worth ebaying them, i bet the e-vehicle peeps would like them.
£20. You'll be lucky to get anywhere near retail in the bot community
will confirm after I have spoken to ian at whitick, to see what is required to run these motors if they are too much trouble they will be put on ebay as too not blowup anymore roboters esc.
They are good disk or pump motors. That is a task these can do with a serious relais, like an Albright SW 80 or bigger.
But alas, disks don't get any playtime in the heavies, and hydraulics is "annoying".
Maybe for an axe?
Perm motors £300 for the pair
Hi All Perms still for sale will be ebay listed this week if I have no further interest
£250 cash buys both motors
very powerful motor unts perfect for axe or spinner drive Battle Bots motors perhaps
Posting Permissions
Reply With Quote
Bookmarks