Is the frame made up from POM?
Printable View
Is the frame made up from POM?
It's 8mm HPDE at the moment at least, trying to keep as thick as poss. Its aluminium top and bottom.
remade the electronics tray with a fuse and a few grams lighter and the battery in a flexible holder that should keep it in place. Fitting flexi blocks on top and bottom of motors as well to keep them in place.
Attachment 9056
That is a very satisfying internal layout! Great work.
Finally finished (apart from the heat treating the tool steel) and its ready to run :)
Attachment 9121Attachment 9122Attachment 9123Attachment 9124Attachment 9125
Very neat looking, rather liking the carry case with it. :D When might we see it run?
Hoping to be getting to Robonerd for starters , but got some brushless on order for MK2
Such a nice build hope to see it at an event some day.
experimenting now with making some wheels. So far I've got some hubs and fashioned a mould and using black rubber shore 60 as tyre. Not too bad, but want to work more on the hub. Its ABS at present, then will be looking at some featherweight versions.Attachment 9137
Time for a rebuild ! Lost the brushless somewhere along the way, so going to try the owobotics ones this time. 6mm shafts on those, so all new wheels needed again I guess. Any off the shelf hubs and wheels that work?