16 Attachment(s)
Regicide (Featherweight) Build
So this has been in the works for a while.
I've been working on this build on and off for about 8 months.
So i'll keep it short. It's a featherweight full pressure flipper.
Attachment 8873Attachment 8884
CAD was first up. Here a picture of the robot without it's armour, base plate, wheels and basically everything but its bulkheads and flipper setup.
Attachment 8874
First step was the pneumatics, then came the cutting out the 6 bulkheads (2 for spares), the inside bulkheads and outside bulkheads are similar to look at are but slightly different. here i was test fitting the gearboxes and drilling the holes to hold the chassis together.
Attachment 8877Attachment 8876
Here's my DIY 20 ton press I made to bend the base to fit the bulkheads.
Attachment 8878
Next up was the vents to cover the tanks for the flipper. This way if it gets really badly damaged basicly half the robot can be swapped out within minutes.
Attachment 8885Attachment 8886
Next up was the flipper arms and the hardox armour. Hardox was super fun to bend :rofl:. cleaned up it was ready to paint.
Attachment 8881Attachment 8883Attachment 8882Attachment 8887
Next was some 3D printing that holds the LED lights. For the top armour the press did a good job and 2 coats of primer and a few coats of white paint made it look ok.
Attachment 8890Attachment 8891Attachment 8889Attachment 8892
After painting I decided I wanted the LEDs to change as the fight go on. (not 100% finished this part yet).
Here is a reveal video of it if you want to have a look https://www.youtube.com/watch?v=PGPV_1oLcwQ
This with be making it debut at Robo Riots in Dublin.
I hope you all like it. Oh and don't worry I asked Gabe from the Tanshe team if I could build this and he gave me the green light to build mini Tanshe.