Reciever Issues

Hey all,

i'm currently in the midst of putting SB back together, and in the process i have created a new wiring loom, with everything modular through JST's.

for the drive i'm still running the "standard" planatary gearmotors wired to a tinyESC each, and into a flysky FS-R6B reciever. This is the setup i ran at bugglebots, and in further iterations.

Everything was working, i stripped it all out, re wired, the ESC's are getting power, but now my reciever flashes red once and then does nothing.

i have also tested on an FS-iA6, and i get no lights at all (this reciever hasnt been tested, so could well be broken).

Checked polarity, checked with a turnigy plush 40A also and no joy. Interestingly when i removed the plush esc the reciever did flash in its bind mode for around 10 seconds before going back to nothing.

i have re-fixed the esc connectors as they were loose and i though could affect operation, but still no luck?

Any thoughts or just new reciever time?

Sorry for the long post, TIA!
Bam

Personally id just get another Rx just to test it. Worse case scenario its not the Rx and you now have a spare (they are relatively cheap anyway).