Hi
I'm looking for a piece(s) of plastic ether:
7x15x2 cmx2 or
14x15x2cm or ideed
15x15x2 cm
Phuee that's a bit of a list! :rofl:
P.S they are for some motor mounts
Printable View
Hi
I'm looking for a piece(s) of plastic ether:
7x15x2 cmx2 or
14x15x2cm or ideed
15x15x2 cm
Phuee that's a bit of a list! :rofl:
P.S they are for some motor mounts
Ebay will be your friend here
What type of plastic? I'm thinking nylon
http://www.ebay.co.uk/itm/Clear-Acrylic ... 343wt_1336
?
go for nylon. Good for structural parts. That perspex is useless. Will crack and shatter after a shock.
Can only find 15mm on ebay
Scrap thos measurement :lol: I have had a better mounting plan still using plastic tho
I need 30x30x2cm
Or 28x30x2cm
http://www.ebay.co.uk/itm/NYLON-sheet-n ... 53e770d238
http://www.ebay.co.uk/itm/NYLON-PLATE-C ... 1c102f7dd5
There's plenty of 20mm available
I must be blind!
HDPE is about half the price of Nylon, I don't know how they stack up against each other for structural use those.
HPDE is softer and more likely to deform hence why it is good for armour. Nylon is better for structural parts as it deforms far less under load and is more dimensionally stable. A thread will also hold in nylon for longer than in HDPE.
For structural parts, as a cheaper alternative to Nylon rather than use HDPE I have used RG1000. Both of which are used in Cicatrix so its quite good for comparison purposed and I havent noticed too much of a difference between the 2 of them in terms of damage/deformity.
Thanks