Wiring Electronize speed controler

i am not sure ho to wire my Electronize speed controler up to me motors, could some one help me?.

I have wired it up once but it only goes forward and back.

I think theyre supposed to go forwards and back, if youre using Electronizes youll need one for each side of the drive for steering...

Could be misinterpreting your problem though.

i have 2 Electronizes one for each motor but i dont know how to wire them all up Correctly.

You could PM Geoff, Woody, or Jonno if you need an immediate answer. :)

If you can give a model number it would be good as there are a few different types (internal/external relays etc.)

Andy

I am using 2 Electronize FR15HVR Microprocessor speed control.

right wire the blue wire from one of the elctronize to the postive on one motor and then yellow to negative

do this for the other motor

you then need a mixer unless you are using a spektrum, i think this will solve the problem

link for a mixer i happen to have a used one if you need it

http://www.technobots.co.uk/acatalog/Online_Catalogue_RC_Input_Mixers___Interfaces_258. htmlhttp://www.technobots.co.uk/acatalog...ers___Interfac es_258.html

top product

if you already have one either switched on on the spectrum or one like above then im not sure

hope it helps, alex

forgot to say you will need to plug the reciver wires into the reciver and put power to the circuit

what motors are you using?

Would i need a
RC speed control Microprocessor 15A
http://www.technobots.co.uk/acatalog/Online_Catalogue_Electronize_Speed_Controllers_351 .htmlhttp://www.technobots.co.uk/acatalog...Speed_Controll ers_351.html
and a
RC speed control Microprocessor 15A Vreg
http://www.technobots.co.uk/acatalog/Online_Catalogue_Electronize_Speed_Controllers_351 .htmlhttp://www.technobots.co.uk/acatalog...Speed_Controll ers_351.html
what is the Difference in the 2

Would 2 RC speed control Microprocessor 15A Vreg work?

I have the batterys, reciver and two drill motors,I am just confused about the speed controllers

Youll need one of each...the Vreg model comes with a battery eliminator circuit which means you can power the reciever/servos off the controller as opposed to using a separate battery.

Two non Vreg ones will work as long as you use a separate battery...two Vreg ones will possibly blow up your reciever. Or so Im told :P