Printable View
hi people, nite b4 event and the hw is playing up! running 4qd speedos. basically when i press backwards on controller, one motor goes backwards the other goes forwards. both motors work off one stick, forwards works fine on both. any ideas? thanks guys
i have also noticed, when you pressed left or right one motor is supposed to go forwards, the other back , but they are both going forwards. the fault seems to be on one motor, it just goes forward fine but when it is supposed to reverse it goes forward:angry:
sounds like your speedo not reversing, most likely its blown. what 4QDs are they? also what interface are you using?
they are ncc 70 speedos, with a dual channel interface
try swapping the signal input cables over (the ones from the interface to the controllers) to determine wether its the speedo or interface.
will try that now, thanks alan
nope, when i changed them over neither motor went forward or backward
it might be the mixing on your tx. mabee inputs on rx. just guessing tho. a swap here and there on the rx might do the trick. or if its a programmable tx it might need programming. i could of course be totally wrong. :)
shane, what do you mean mate, they are not programmable controllers. your getting too technical for me:crazy:
i tried :) its probably simple. i hope it is anyway