PMEUMATICS

Yes ...you could use 1/4 copper tube or pipe .... you will however need to source the correct fittings and olives.

I'd recommend nylon or plastic together with push fit fittings.

1/8 ports on the cylinder and valve together with 6mm o.d. tube should be fine for your proposed set up.

Ok thank alot

Would this be right

http://www.technobotsonline.com/nylon-t ... ral-m.html

and is that 1 meter long

yes and yes

Thx am going to buy some

or you could buy a 30 metre roll on ebay for £18
Obviously this is 10mm but im sure they do diff. sizes

http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWNX:IT

Yer or just buy 30 times on tecnobots for about £16

Im currently building too...

Ive got 5/2 valve with 1/4 bsp ports with 10mm pipe and 1/4bsp fittings on the ram will this be sufficient??

What regulators you using peoples? I need one asap.

Your building a feather?
Your ram size?

OR ...Download Noel's flipper calculator

http://www.hassockshog.co.uk/flipper_calculator.htm

yes im building a feather...
the ram is a small hydraulic ram... id say it was 30mm wide and the stroke is about 80-100mm