Rebel Robots

I dont think Hooligans aluminium wedge is going to do too well against spinners.

No worries mate, you know where I am if you need some :)

tom, i know i can take real big chunks out of 6mm mild steel if that helps, its mainly any sharp corners you need to worry about (sides of wedge) i never really do alot to front of wedge unless i get a lucky hit. also round the sides and back is where you mainly get the most damage. if your worried/came up against me just stop moving and i would understand you have had enough and leave you alone from then on. the best advice is always drive flat out and front on at a spinner, that was the advice i was given and it worked well for me.

(Message edited by ady on December 15, 2008)

Tom at the fw uk champs this year, 4 4 toon got well and truly trashed by Hornet but kept on running,as did Block of Wood.Just go for the spinners full on and worry about the consequences later,its a great laugh beleive me.

If im driving Hooligan it will be full on all the time. It took me a night and a bit of a morning to build so it can be very easily rebuilt after the event. The outside frame is 60mm x 40mm x 3mm Mild Steel Box Section so you spinners are going to have a hard time getting to the electronic bits inside. Only thing is i wanna repaint it and i wont want the paintwork scratching.

look on youtube to find out how to rly beat a spinner

What am i looking for?

http://www.youtube.com/watch?v=Z-BLc9ZjOyE&feature=channel_pagehttp://www.youtube.com/watch?v=Z-BLc...e=channel_page

their you go. prodigy my first ever rambot
against little spinner, cant remember the other robot off hand, it was having drive problems that day i think.


(Message edited by ady on December 15, 2008)

tom, will look for a link later but robots who go flying into megabyte normally come off worse then megabyte

http://www.youtube.com/watch?v=TlFBuJjIh9A&feature=channelhttp://www.youtube.com/watch?v=TlFBu...eature=channel

a vid of my spinner before single tooth conversion