2.4 ghz - transmitters

no

1. depends on the receiver

2. no

Different manufacturers have different methods for connecting transmitters and receivers but the overall method is for the receiver to be bound to a transmitter. Generally the transmitter emits a specific code which the receiver is listening out for when it's turned on. When it gets this signal it will act on the instructions that the transmitter sends.

Different manufacturers 2.4gig radio gear will for the most part NOT work together as they are looking for different codes and use different methods to bind.

thanks for the help folks

Quote:

---

Originally Posted by k_c_r

Grab a cheap old 35MHz/40MHz transmitter off of eBay, such as:

http://cgi.ebay.co.uk/Futaba-Skysport-6 ... 415b546cb1

Then convert it to 2.4GHz using DIY kits. This allows you to use all the fancy features of a more expensive radio but means you don't have to fork out lots of money to be using 2.4GHz. The conversion process itself is very straightforward and involves drilling a couple of holes and soldering a few wires.

I've used the Corona modules, that Gary has linked to, in the past. But they've not been 100% reliable for me, and since I've used FrSky modules, I've not had any problems. Instant bind, programmable failsafes in the receiver, and nice and cheap :)

The FrSky DIY module:

http://www.giantcod.co.uk/frsky-24ghz-c ... 05206.html

And 4-channel, 7-channel and 8-channel receivers:

http://www.giantcod.co.uk/24ghz-frsky-r ... 04806.html
http://www.giantcod.co.uk/frsky-receive ... 05458.html
http://www.giantcod.co.uk/24ghz-frsky-r ... 05319.html

And, if you choose to opt for this method, a few posts from forums that go through the conversion process:

http://www.rcgroups.com/forums/showthre ... hlight=ff6
http://www.rcgroups.com/forums/showthread.php?t=878096
http://www.rcgroups.com/forums/showpost ... ostcount=8

---

HI which 24ghz-conversion would be compatible with a futaba t6x.
Thanks
ROB....

All should work, they connect to the back of the trainer port, and read the PPM stream. Ive used the FrySky hack system on a Skysport 6 and a 6EXA, with no problems. Would really reccomened these, i bought one of the modules to fit my FF8, which I use on the mechanoid. Never had a problem with range, bind instantly.

Frsky i think

Cheers I will order the frsky then.
Just hope i can get the wires soldered to the right pins. :crazy:

Can't find a BR6000 for your dx6

Quote from a RC Forum.

Good find! Was hoping that I wouldn't have to get rid of my DX6