Electronize controllers

I just took mine out the box and wired them up :lol:

Same! I never tweaked anything, don't seem to need to. :)

You might find the bot responds better if you play with them. Experiment and see what works

I would recommend you read the instructions on them
And then spend some time playing with them to get the best response for your robot control.

The speed adjustment for what you want you just put it at full speed and leave it there. this function is for things like trains or boats you may not want to go too fast!

Frequency control Low frequency gives better low speed grunt or pushing power, high speed better power at high speed in the middle a bit of both :mrgreen:

I use this speedo for an axe motor control so I have got it set on low frequency it seems to get things going a bit quicker the motor probably doesn't get up to full speed anyway:D

I always used them on low freq', seemed to give abit more power. With the speed setting, set it to full, then hold the drive on full throttle, whilst at full throttle slowly turn down the speed pot' until you hear the drive start to slow, then turn it back a little. This means you have better control over the speed range and dont have a dead spot at the top end.