Spinner balance / stability

Hi all! Complete newbie here, working on my first beetleweight. Only ever done RC cars and planes before, which is simple compared to this! I have come up with a rough idea of how the spinner on my beetleweight will be mounted, but just wanted some feedback regarding strength and balance. I have got a rough sketch that I have just knocked up in MSPaint (work PC doesn't have anything better on it). This will be a vertical spinner.

Red is the blade itself.
Blue is the hub, which I will turn out of aluminium, and the blade will be bolted to.
Grey is the bearings.
Orange is the spindle.
Green is the pulley (belt driven) which will be fixed to the hub from the other side.

Picture is not anywhere near scale. First impressions? If its complete junk, say so and I will go back to the drawing board :D

Attachment 6664

Cheers!

Ian

That's pretty much how I mount my discs but instead of a single hub I mount a hub on one side and the pulley on the other with at least 1 bearing in each to spread the force along as much of the shaft as possible.

Thanks Jack, much appreciated. Good to know I am at least on the right track :) I have had a couple of bits delivered, speed controller and battery. Motor is on the way. The speed controller is a Turnigy AE-30A, and I have got a Turnigy 3S 11.4V 850mAh battery pack. Hopefully these will do the trick? The motor I have ordered is this one: https://hobbyking.com/en_us/ntm-prop...___store=en_us - this is all just for the spinner. I understand for a 2wd system I will need a dual-motor speed controller, so will look for this later :)

I use the same battery in all my beetles, they've been absolutely fine in my experience. The motor you've got might struggle a bit though depending on how heavy your weapon is, I ran 28-26's for a while and they struggle initially to move anything more than 250g. I swapped to the 28-36 1400kv on all my machines and haven't had issues with them yet.

In terms of drive controller I run brushless drive on my beetles so use 2 reflashed Afro 12a on brushless converted 1000rpm gearboxes, they're a bit finicky to get working initially but they were great in Tempus and Phobos throughout the Burgess Hill event.

Thanks Jack, thats awesome. I was at the Burgess Hill event as a spectator, Beetleweights were a highlight for me, utter madness!