ian swan interface

hey, going to have one last atempt to get this to work before i get another one
does anyone know where to get a manual for this? searches didn't bring up much info.
http://i947.photobucket.com/albums/a...uin/003-48.jpg
i noticed that there are small bits of wire joining some terminal blocks together, should i remove them?
i get a single red light on the interface when i put the 6v into it, should anything else be lighting up?
i have installed the disc that came with it on my laptop, is there something i have to do on that?

i apologise for asking the stupid questions :oops:

Leave the wires they are needed.

The red light shows power is getting to it, when it receives a radio signal it changes to green.
With everything on, I'd plug a servo into the rx into another channel and see it you have control of it.

John

thanks very much, ill give that a go

the servo works fine, i can see the led beside the red one flickering slighly though.
i had a though, with some of the antweight contolers won't work with the cheap dsm2 rxs or corona ones, would the interface have this?
http://www.youtube.com/watch?v=FRjE0-u-wSs

I think you might be powering it twice...

Are you putting 9v into the board and using a receiver battery ???

You only need one of the above .

ah right, oops!

Well try just powering the receiver .

There will be a dim reflection on the green led, but the red needs to go out and green on,

got the same result from just having a 6v in the rx :?

I had this issue with md, it turned out that a jumper had come off, I'll have a look today at one and see which one it was, I'll post a pic tonight when I get back.

Other than that I dont know anything else to try.

thanks a bunch, apreciate all the help.