Tab Content
  • McMullet's Avatar
    18th November 2019, 21:02
    Looks marvellous! Looks... toasty in fact. :D Great job getting it up and running. Could you fit a polycarb panel to the top with some (decorative) slices of "toast" sticking out? Just cut from...
    57 replies | 7811 view(s)
  • McMullet's Avatar
    18th November 2019, 20:52
    That's quite the year you've had. I think it's a good decision to ease off the driving a bit, it can't be much fun spending so much time in the car for a couple of fights. Great to see Jibril's...
    177 replies | 123919 view(s)
  • McMullet's Avatar
    18th November 2019, 20:45
    Well done on your first event! I was watching the live stream and recognised Landslide when it came up - I won't deny, I had a bad feeling about how it was going to go but you did brilliantly! Very...
    18 replies | 914 view(s)
  • McMullet's Avatar
    14th November 2019, 11:32
    Bravo sir. I hope it drives well and the event is successful, but regardless of functionality you are a true artist when it comes to bending HDPE!
    111 replies | 42928 view(s)
  • McMullet's Avatar
    14th November 2019, 11:26
    McMullet replied to a thread Get Shrekt in Build Diaries
    That is an impressive set of damage photos! It's great to see all the little incremental changes you've made to make GS the monster it is today. Hopefully see you at Robodojo in a couple of weeks...
    18 replies | 5363 view(s)
  • McMullet's Avatar
    11th November 2019, 23:31
    Looks great! My understanding is that PLA+ is tougher in the formal engineering sense, but then "tougher than normal PLA" leaves a lot of room to not really be very tough...
    6 replies | 299 view(s)
  • McMullet's Avatar
    10th November 2019, 22:46
    If they're normal Argos drill motors the gearboxes are single speed, so no worries there! I've found going in a straight line at low speed a challenge too, I think basically what happens is that the...
    57 replies | 7811 view(s)
  • McMullet's Avatar
    10th November 2019, 16:15
    Looks great, I'm impressed by all the graphics! I use F360 a lot but I never bother making anything look pretty. I'm also planning out a 3D printed PLA ant, so I'm interested to see how you get...
    6 replies | 299 view(s)
No More Results
About McMullet

Basic Information

About McMullet
Name:
Sam
Location:
Nottingham
Occupation:
Battery engineer
Robots:
Ensign Wedgeley Crusher (FW)

Statistics


Total Posts
Total Posts
174
Posts Per Day
0.18
General Information
Last Activity
Yesterday 23:53
Join Date
8th April 2017
Referrals
0