Tab Content
  • Shooty's Avatar
    Today, 17:35
    Almost all of my internal cuts are done with a jigsaw, which usually explains why they end up looking rougher than normal cuts. If I wanted to cut a box for instance, I'd draw the box, add a chamfer...
    5 replies | 418 view(s)
  • Shooty's Avatar
    Yesterday, 17:33
    I notice in your last picture that one of the metal pins on the gearbox has come loose. if one of those comes loose, the entire planetary setup can come loose or seize as well. I'd recommend putting...
    48 replies | 5478 view(s)
  • Shooty's Avatar
    Yesterday, 09:47
    Sorry for delay in reply. HDPE is really good for press fitting like you said, especially if the holes are undersized. For Léim Thart, I needed to press in a 1/2 inch bearing, and for that I just...
    5 replies | 418 view(s)
  • Shooty's Avatar
    16th June 2019, 23:55
    FOLLOW-UP: This video from Team Saint covers a few extra tips for HDPE cutting. the blade being used here will likely be too big for many cuts necessary, especially at lower weight classes, but the...
    5 replies | 418 view(s)
  • Shooty's Avatar
    16th June 2019, 23:46
    So I've been working fairly non-stop on beetleweights and featherweights for the past two years, and each of my builds have involved robots almost entirely constructed out of HDPE. I have a lot to...
    5 replies | 418 view(s)
No More Results
About Shooty

Basic Information

Age
20
About Shooty
Name:
Eoin
Location:
Galway, Ireland
Robots:
Barróg (FW), Barróg Doom (FW) -In Progress-, Léim (BW)

Statistics


Total Posts
Total Posts
116
Posts Per Day
0.14
General Information
Last Activity
Today 20:42
Join Date
17th February 2017
Referrals
0