Tab Content
  • Ocracoke's Avatar
    Yesterday, 00:33
    Hahaaaa, thanks! Didn't really fancy being rammed into with the metal arms sticking out of it. Sounds promising. I need to read on the specs of the RageBridge but I need it running 8S LiFe...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    Yesterday, 00:26
    Hey there! I still use Gimsons in my Featherweights, solid reliable units. You can get a 13.7:1 motor and gearbox for about £50 per side (though the last time I looked on the Gimson site was a...
    1 replies | 64 view(s)
  • Ocracoke's Avatar
    21st February 2020, 09:42
    Thanks, will try to remember that for future cutting! It was more a case of "I want it done" and where they were going on the robot (to hold the wheel on) didn't require that much in the way of...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    21st February 2020, 02:16
    Jibril Well it has been a bit of a slog in places. Turns out the bolts I found were 80, not 90mm long and ended up having to carve up some 100mm long bolts to make proper length driveshafts on the...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    18th February 2020, 15:16
    Hahahaa! It might be made to be scared a little sooner than I thought. I found some 90mm long bolts that will work as drive shafts and the shaft mounts will take a M6 bolt without adaptation (they...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    17th February 2020, 23:21
    Following on from the last post, I've been busy. Tada! I'll be running out tomorrow to get some M10x100mm bolts or something to screw the motor mounts down with along with some coarse...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    17th February 2020, 01:24
    Jibril So yeah, this weekend didn't go to plan. Managed to get the drive templates made but in cutting the drive shafts, need to go outside to that really and it has been too wet to do so. Still, I...
    216 replies | 138551 view(s)
  • Ocracoke's Avatar
    15th February 2020, 15:00
    We'll see closer to the time. Had a bit of a setback here which means I can't work on it this weekend. It'll happen.
    7 replies | 521 view(s)
  • Bad Wolf's Avatar
    13th February 2020, 21:10
    Yeah im excited to hopefully have some new bots sorted by then too! I have a couple of those strip LED lights if you need them, they plug into the mains they arnt battery though. Bad Wolf
    7 replies | 521 view(s)
  • Ocracoke's Avatar
    13th February 2020, 13:48
    Nope, no deadline really. Signups are open up until the event starts.
    7 replies | 521 view(s)
  • Ocracoke's Avatar
    13th February 2020, 10:06
    Excellent, glad to hear the event is being looking forwards to! With any luck, I will have the arena's floor lifted up a little over the weekend and the pit floor painted.
    7 replies | 521 view(s)
  • Ocracoke's Avatar
    10th February 2020, 22:41
    Hahahaa, true enough! I've got a 10mm spade bit somewhere, will bear that in mind for future use.
    216 replies | 138551 view(s)
  • Bad Wolf's Avatar
    10th February 2020, 21:18
    Cant wait for the event :) Bad Wolf
    7 replies | 521 view(s)
  • Ocracoke's Avatar
    10th February 2020, 12:14
    It is time for the next BotFest event! Location St. Lukes Church Poulton Wallasey CH44 3BD Date 25th April 2020
    7 replies | 521 view(s)
  • Ocracoke's Avatar
    10th February 2020, 02:41
    Jibril The HDPE base panel has been drilled. Doing 32 holes three times over in 3, 8 and 10mm bits is nuts but there you are. Currently mocking up the motor mount bolt pattern on a 1mm sheet of...
    216 replies | 138551 view(s)
No More Results
About Ocracoke

Basic Information

About Ocracoke
Name:
Lucy
Biography:
A Smart Car obsessed roboteer!
Location:
Somewhere on the Wirral
Interests:
Smart Cars, programming etc
Occupation:
Something computer based
Robots:
AW: Amai, Ikari, Lafiel, Osu, Ramu / BW: Shu!, The Honey Badger / FW: Azriel / MW: Jibril, Kaizen

Signature


Team Kaizen - Build Diary for all the robots

AW: Amai, Ikari, Lafiel, Osu, Ramu
BW: Shu!, The Honey Badger
FW: Azriel
MW: Jibril, Kaizen

Statistics


Total Posts
Total Posts
1,120
Posts Per Day
0.97
General Information
Last Activity
Today 03:15
Join Date
20th December 2016
Referrals
0
Home Page
http://teamkaizen.ocracoke.org.uk/index.php

4 Friends

  1. Bad Wolf 
    Status
    Offline

    Roboteer

    Bad Wolf
  2. joebrown 
    Status
    Offline

    Roboteer

    joebrown
  3. Maxamuslead 
    Status
    Offline

    Roboteer

    Maxamuslead
  4. Theo 
    Status
    Offline

    Member

    Theo
Showing Friends 1 to 4 of 4