Jibril
Work has happened. Very descriptive, I know :P The chassis has been modified a little to allow the axe motor and carrier to come out in one piece. The U bolt holding the back of the motor in...
*FANFARE*
I have now received the assemblies, screws and motors. They arrived by carrier this morning.
I will be putting them up for sale soon, once i have QC checked them and my packaging has...
Hooray! It's looking a bit vague at the moment but it sounded like pubs would potentially be allowed to do outside service by mid April, so if I can go and have a pint in a beer garden I would've...
I did consider a outdoors event and I am open to considering it. Nothing is set in stone.
Yeah, I hope we can have this too. :P As I understand it, AWS 62 hasn't been scheduled yet? I'll need...
Hi Lucy
If you could organise an outdoor event-maybe under a gazebo I believe 27th of March is the official
start date for sporting events outdoors though it's up to the individual to assess when...
OK, so following the announcement of the provisional roadmap by the government, my proposal is to have BotFest 4, finally, at the end of June though this does depend on, amongst other things, A)...
Hi,
I'm working on a new project and need some 6S ideally 5Ah batteries. They do not need to be new but good working condition, will not be pulling a huge current.
Anything safe, and cheaply...
The link Jamie posted is where I got my set from.
The gears I get (from gearsandsprockets.co.uk) have hubs attached to them though not all have hubs. They are labelled if they don't.
...
Hi guys. Thank you. CIM does look like a good option. I have never used gears as I am very new to this stuff so have a few questions that may seem silly.
1) Where do you actually buy them from?...
I have indeed used CIM motors on the original Kaizen axe, Azriel 0.9's axe and still in Jibril's drive system. They are quite robust little motors but they aren't especially torquey. They do indeed...
One option for an 11.1V system is a 'CIM' motor. They're rated at 5300rpm at 12V and not too expensive. The downside is that it would need gearing down, perhaps around 10:1, but that would be true of...
You could potentially use a 12v scooter motor that will run at full capacity, but tend to be 150 watt or abouts. I used one in wanna choppy, an axe bot that was low in height so had to use a smaller...
Its going to be underpowered. It'll move sure but it's going to be underpowered by over 50% to the point where I can't really see it performing adequately, even if it is going to be flailing a mace....
Thank you. We will be using a battery that is 11V and the motor you linked, and most of what I have seen on ebay, are 24V. Will they work on 11V or would that be too underpowered?
Hi. After asking around about various things including pneumatics but have decided that might be out my reach at the moment for a first attempt at a featherweight.
Me and my friends (after many...
Hey all,
i'm currently in the midst of putting SB back together, and in the process i have created a new wiring loom, with everything modular through JST's.
for the drive i'm still running the...
