Register To Comment
Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Certification of Full Pressure Ram

  1. #21
    Roboteer

    Status
    Offline
    Name
    Jeremy Cuss
    Robots
    Herbinator (a long time ago)
    Location
    Huddersfield
    Posts
    16
    Post Thanks / Like
    Today the ram with the new seal has been tested and certified at 90barg. Hurrah! There was a small leak of water past the O ring, but nothing of any consequence. I have now got a ram which meets FRA and Robot Wars rules for custom-built components when used with full-pressure CO2. I ended up going to a local firm, Hebble Hydraulics, for the pressure test on the ram. This was a lot easier than going back to the West Midlands. The cost of £40 was the same as I was charged by HPAC.

  2. #22
    maddox10's Avatar
    Member

    Status
    Offline
    Posts
    2,327
    Post Thanks / Like
    Good to hear. After 13 years of idleness that ram finaly can fullfill its destiny.

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •