Register To Comment
Results 1 to 5 of 5

Thread: Disc for Antweight

  1. #1
    After a disc/blade to be used for an antweight spinner. Preferably one that can be fitted to a DYS BE1806 2300KV brushless motor.

  2. #2
    What diameter are you looking for? I have plenty spare that should fit, but they're about 40mm across, 3mm thick stainless.

  3. #3
    I could give 40mm doesn't sound or seem bad and I'm willing to give it a shot. Any chance of a photo of the disc?

  4. #4
    I've got some twin tooth 60mm dia ones if you're interested Harry? I designed them to take a 3d printed hub to fit around an outrunner motor

  5. #5


    Any one of these (or two of different kinds) is fine. I need the rest for spares. Just a couple of things: The holes are slightly less than 2mm in diameter, so you'll need to drill them out a bit. It doesn't take too long. The single-tooth blade should be balanced, but I haven't tested it yet, so I'm not 100% sure.

Register To Comment

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •