Making my own wheels

[shakesc]

So I decided I wanted to make my own wheels

Previously I have bought robo challenge wheels to screw onto the end of drills

Moving to Gimsons the threaded section leaves alot of plain 12mm shaft


So I decided to make wheels that utilise this part of the shaft

[shakesc]

I bought some banebots orange 100mm wheels


I'd previously obtained some linear bearing shaft supports to try off ebay
e.g. SHF12 12mm Linear Bearing Shaft Support (12mm ID x 24mm OD x 12mm L) Hi-Q

[shakesc]

I drilled out the wheel with a 12mm drill. I have a drill press now that makes it alot more accurate than a hand drill
I used a router to make the face flat on the wheel to mount the support
I then mounted the support to the wheel with 5mm bolts


Relieved the area around the nut, again with the router, so the nut (self locking) would sit flat

[shakesc]

Finally this give a package looking a bit like


Havent yet decided what to do about the additional bearing support (i.e. is is needed) and the spare shaft length

[RogueTwoRobots]

A very nice assembly there, effective yet still simple enough for most people to try.

I personally don't think you need to worry too much about an extra bearing support, although I don't imagine there would be anything wrong with adding one. Your wheel currently sits quite close to the gearbox, similar to where it would be on a standard drill motor. The extra bearing supports were recommended because the threaded part of the output shaft, to which a wheel is normally screwed on, is much further out than usual and the shaft could have been more prone to bending, but you've minimised this issue with your design.

[shakesc]

Thanks, the tools I have dictate my design ambition

My favourite tool is an engineers vice. Just can't believe I didnt buy one sooner. The amount of skin I lost before I bought it is not worth thinking about.
The drill press is a Christmas present and given the number of holes I find I drill this is going to make life alot easier.