Tab Content
  • lowndsy's Avatar
    Yesterday, 21:44
    lowndsy replied to a thread Project Squirrel in Featherweights
    You can screw straight in if you have to, but a pilot hole helps a lot. There was some discussion a few weeks ago about multiple BEC power supplies from multiple escs on one receiver. It boiled...
    8 replies | 321 view(s)
  • lowndsy's Avatar
    19th May 2017, 14:12
    Thanks, I think! It is just plain heavy all over, but there is a pretty sizable armour plate to bolt onto the back so weight on the axle shouldn't be a problem. I am considering trimming a...
    59 replies | 7123 view(s)
  • lowndsy's Avatar
    19th May 2017, 13:18
    Nope, it's a pair of caravan ramps. Good for 8 tons of pressure, and even after I hacked it up and bolted the armour on I drove my Renault Megane over it with no problems. Impact damage and point...
    59 replies | 7123 view(s)
  • lowndsy's Avatar
    18th May 2017, 21:06
    Right, back on the wagon after being super busy at work. I stripped down FD tonight to replace the drill motors with new Gimsons. The crimped wires are just temporary until I shorten them, but...
    59 replies | 7123 view(s)
  • lowndsy's Avatar
    17th May 2017, 10:16
    When I was still on drill motors I found these wheels http://www.screwfix.com/p/select-rubber-wheel-150mm-diameter/8359p Work well with this nut: ...
    28 replies | 916 view(s)
  • lowndsy's Avatar
    11th May 2017, 08:18
    lowndsy replied to a thread Esc Advice in Featherweights
    People do run Quicruns in competition so they are doable. I had a couple blow up the other weekend but to be fair I was using meaty motors and 75c 4s LIPOs and I think my signal mixer was playing up...
    21 replies | 844 view(s)
  • lowndsy's Avatar
    10th May 2017, 21:59
    I was going to tell the gold joke! I got a couple of spare screws from the German guy, but as a backup for the backup I picked up some lh threaded bar and half height nylock nuts, just in case. Not...
    74 replies | 7878 view(s)
No More Results
About lowndsy

Basic Information

Age
35
About lowndsy
Name:
Steven Lownds
Location:
Stoke-on-Trent
Robots:
Flat Damon

Signature


Statistics


Total Posts
Total Posts
97
Posts Per Day
0.39
General Information
Last Activity
Yesterday 22:23
Join Date
14th September 2016
Referrals
0
Home Page
http://www.rigidrobotics.co.uk/

19th May 2017


18th May 2017


8th May 2017


3rd May 2017


24th April 2017


8th March 2017


13th February 2017


28th October 2016


27th October 2016