Tab Content
  • Draper's Avatar
    Today, 10:30
    They are t nuts used in furniture, I drilled out the metric thread and cut a new imperial thread.
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 23:08
    The front prongs were made next, these are from 20mm hdpe with 3mm aluminium on top. A lot of trail and error was needed in making sure they stayed flush with the floor without lifting the wheels up....
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 23:05
    The front wedge was created, this was made from thick 20mm hdpe. It made the frame a lot more rigid.
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 23:03
    The actuator was next mounted into the from, this was tricky as a hole had to be accurately drilled through four different parts in order to create the anchor point. The hole was also reinforced with...
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 22:51
    The actuator has an attachment that allows it to bolt onto the claw, I am having this made for me at a local machining workshop. Before sending the drawings over I first 3D printed a prototype to...
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 22:45
    Then wheels where also cut from hdpe using the same dremel attachment and had bike tyre screwed into them. Since the wheel had to be a certain height and it's difficult to accurately measure the...
    26 replies | 1772 view(s)
  • Draper's Avatar
    Yesterday, 22:37
    The central weapon mounts were finished with the new plastic and work was done on the motor mounts. These were cut using a dremel with a circle cutting attachment.
    26 replies | 1772 view(s)
No More Results
About Draper

Basic Information

Date of Birth
August 20, 1992 (26)
About Draper
Name:
James Draper

Statistics


Total Posts
Total Posts
17
Posts Per Day
0.02
General Information
Last Activity
Today 12:41
Join Date
2nd March 2016
Referrals
0